Release Notes

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.1.7 Page 35
Missing port
membership
from SNMP
(dot1qVlanStati
cUntaggedPorts
and
dot1qVlanStatic
EgressPorts)
Changing VLAN configuration for general
mode affected trunk mode configuration
and there from the port membership
returned via SNMP.
Corrected the issue. All 4.2 supported
platforms
The VRPP track
port priority
changes in the
running config
The VRRP track port priority in the running
config is retrieving the operational value
instead of the configured value.
Corrected the retrieval of the
configured value
All 4.2 supported
platforms
Firmware won't
allow domain
names with
hyphen "-" in
logging email
The hyphen is part of the allowed characters
available for the email address.
Added the hyphen to the
allowed characters for email
addresses.
All 4.2 supported
platforms
Internal ports
are up during
most of the
switch POST
Internal ports were up while switch is
booting, this was causing traffic loss in
network.
Corrected the initialization of
the internal ports. CPLD Code
Update is required.
1. Update the CPLD using the
command 'dev cpldUpdate'
Console#dev cpldUpdate
2. Power cycle the switch.
(Power Cycle from CMC
WebUI. Do not run “reload”
from the console prompt)
PCM8024-K
Continuous log
message at
default settings
POE log message comes up during power
up sometimes.
Removed unwanted message. PC7024P/PC7048P
DNS client error
The meaning of the DNS error message:
“DNS Client: osapiSocketRecvFrom
returned error for addr 0x1214BCA8” is
unclear.
Corrected the text of the
message.
All 4.2 supported
platforms
VRRP
Intermittent
Connectivity
Issues
Ping to a remote host will not work if
switch acts as VRRP master
Corrected a VRRP
communication issue.
All 4.2 supported
platforms
VLAN
membership
port names not
consistent in
GUI
VLAN membership port names are not
consistent.
Corrected the port numbers
displayed in the GUI.
All 4.2 supported
platforms
Radius crash
Sometimes switch crashes when receiving
of Radius packets
Corrected the crash. All 4.2 supported
platforms
In a Stack, the
"show system
temperature"
CLI command
breaks CLI
CLI output for command "show system
temperature" is corrupted when
pagination is used because the stack
displays much more data.
Corrected the pagination issue. All 4.2 supported
platforms
QOS on port
channel
There is no way to see the match packet
counts of a policy-map on a port-channel.
Command "show policy-map
interface port-channel <port-
channel number>" was added.
All 4.2 supported
platforms