Release Notes

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
System Firmware Version 5.1.1.7 Page 39
Line "no
passive-interface
Vl32" in startup-
config does not
get loaded on
startup
The following is displayed when startup-
config is loaded:
Applying Global configuration, please wait
...
Applying Interface configuration, please
wait ...
******* The following lines in "startup-
config" failed:
******* Line 57:: no passive-interface
Vl32
Corrected stored config
All 4.2 supported
platforms
Web GUI
Admin Duplex
setting on 10G
Fiber ports
Switching-->Port-->Port Configuration
Select a ten gigabit interface Te1/0/1 and
you can see that "Admin duplex" and
"speed" are still active and can be changed,
but when you apply it gives an error
message saying "
Error failed to set current auto negotiation
with disable".
Invalid selections disabled on
page load.
PCM6348
Advertise LLDP
Management
Address as IP
Address
assigned to
OOB interface
LLDP advertises the switch's MAC address
as the Management Address. Request to
advertise the management IPv4 or IPv6
address instead.
The following behavior is now
implemented:
1) Will advertise service port
address if it is there
2) If service port is not there,
then will send network address
3) If both of the above are not
there and if it is routing
interface will send IP address
of the routing interface
4) If none of the above not
there, will send MAC address.
All 4.2 supported
platforms
PCM6348 - Log
message output
Messages repeated in the switch logs
<190> APR 28 19:39:22 10.1.208.10-1
STATSMGR[239558880]:
collector.c(1066) 3445 %% Failure in
function collectorGet
<190> APR 28 19:39:22 10.1.208.10-1
STATSMGR[239558880]: presenter.c(102)
3446 %% ERROR!! Failure in preStatsGet
0x0002011e
<188> APR 28 16:40:31 10.1.208.10-1
ARP[301140128]: ipmap_arp_api.c(855)
3325 %% Received ARP Reply on interface
Vl208 with bad target IP address
255.255.255.255. Sender IP is 10.1.209.60,
sender MAC is 76:f7:b9:cf:06:7e.
SNMP walk/gets on counters
for CPU/vlan routing ports not
supported by platform no
longer log a warning message
All 4.2 supported
platforms
Firmware
missing port
VLAN
membership in
the GUI
Port VLAN membership will not be shown
in the GUI.
Web code updated to display
VLAN membership
PCM6220