Release Notes

44 System Firmware Version 5.1.1.7
Summary
User Impact
Resolution
Affected
Platforms
PCM6348 - Log message
output
SNMP walk through unsupported counters
cause error messages
Change the logging priority
of the messages for
unsupported counters so that
they are not output.
All Platforms
Missing port VLAN
membership in the GUI.
If switch has less than 24 ports, Port
VLAN membership will not be shown in
the GUI.
Corrected the VLAN port
data issue.
PC70xx
Routing fails on VLAN. Removing a VLAN routing interface
causes routing to be lost across the entire
switch.
Corrected the VLAN
interface removal problem
PCM6220
PIM BSR join messages. PIM Join messages using wrong RP
Address
Corrected Join without a
Prune condition.
All Platforms
PIM-SM Not all data passed
down to the RPT.
When network re-configuration happens,
the multicast traffic may not properly
converge thus resulting in loss of some
traffic.
Corrected Join condition. All platforms
Port Configuration page gets
errors on 10GB ports when
any setting is changed.
Port Configuration page gets errors on
10GB ports when any setting is changed.
Corrected Web page error. All Platforms
PIM-SM RP Fails to send
Register Stops.
Register-Stop messages may not be sent
out on the correct interface through to the
First Hop Router.
Corrected Register Stops
message error.
All Platforms
IGMPv3 querier sent in error
with source address 0.0.0.0
Switch will get moved to non-querier
mode if an IGMP membership query
arrives with source address 0.0.0.0.
Corrected valid address
check for membership query
packet.
All Platforms
PIM-SM Joining messages
using wrong RP address
PIM-SM Joining messages using wrong
RP address
Corrected Join message
processing.
All Platforms
Fails to reconfigure and
forward multicast message
Switch fails to reconfigure and forward
multicast messages following link failure
Correct an RPF information
problem when link goes
down.
All Platforms
DNS client error in logs and
switch locks up and needs to
be rebooted.
Error message “DNS Client:
osapiSocketRecvFrom returned error for
address 0xAABBCCDD” being logged
Corrected error in task that
handles changes of the
Service Port link status
All Platforms
PIM-DM Prune states
expiring.
The router might end up sending Graft
messages even though there are no
intended hosts.
Corrected a PIM-DM
timeout error.
All Platforms
Email alerts do not contain log
message.
Current e-mail messages display in e-mail
applications with a blank body, log
message is not displayed.
Corrected error in email
header section.
All Platforms
log message "internal interface
number 183 out of range" is
seen.
Message: “nimCheckIfNumber: internal
interface number 183 out of range” is
displayed.
Corrected error in VLAN
create web page
All Platforms
"no enable authentication"
does not disable access to
privileged EXEC over the
telnet line
"no enable authentication" does not
disable access to privileged EXEC over
the telnet line
Corrected error in
authentication processing.
All Platforms
dot1q_api.c error during MIB
walk
If LAG port is configured as general trunk
then log message is getting printed when
snmpwalk is accessing the MIB OID
agentLagSummaryAccessVlanID.
Corrected VLAN access
error.
All Platforms
sFlow Timeout settings for
CLI command
sFlow receiver timeout value should be
optional
Changed receiver timeout
value to be optional.
All Platforms