Command Line Interface Guide

DHCPv6 Commands 1011
Syntax Description
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC, Config mode and all Config sub-modes
User Guidelines
This command shows the DHCP status. Information displayed depends on
the mode.
The command output provides the following information for an interface
configured in client mode. Not all fields will be shown for an inactive client.
Parameter Description
interface-id Any valid IP interface. See
Interface Naming Conventions for
interface representation.
Term Description
Mode Displays whether the specified interface is in Client, Relay, or
Server mode.
State State of the DHCPv6 Client on this interface. The valid values
are:
INACTIVE, SOLICIT, REQUEST, ACTIVE, RENEW,
REBIND, RELEASE.
S er v e r DUI D D H CP v6 U ni que Ide nt if ier of t he D HC Pv 6 S er v er o n t hi s
interface.
T1 Time The T1 (in seconds) time as indicated by the DHCPv6 Server.
T1 value indicates the time interval after which the address is
requested for renewal.
T2 Time The T2 (in seconds) time as indicated by the DHCPv6 Server.
T2 value indicates the time interval after which the Client
sends Rebind message to the Server in case there are no replies
to the Renew messages.
2CSPC4.X8100-SWUM100.book Page 1011 Wednesday, August 29, 2012 6:23 PM