Command Line Interface Guide

1070 IP Routing Commands
from different sources have the same preference, PowerConnect routing
prefers a static route over a dynamic route.
Static Reject Routes
To administratively control the traffic destined to a particular network so that
it is not forwarded through the router, PowerConnect enables configuring a
static reject route for that network on the router. Such traffic is discarded and
the ICMP destination unreachable message is sent back to the source. Static
reject routes are typically used to prevent routing loops.
Default Routes
PowerConnect routing provides a preference option for the configuration of
default routes. A configured default route is treated exactly like a static route.
Therefore, default routes and static routes have the same default preference.
Commands in this Chapter
This chapter explains the following commands:
encapsulation
Use the encapsulation command in Interface Configuration (VLAN) mode
to configure the Link Layer encapsulation type for the packet. Routed frames
are always ethernet-encapsulated when a frame is routed to a VLAN.
encapsulation show ip interface
ip address show ip protocols
ip mtu show ip route
ip netdirbcast show ip route configured
ip route show ip route connected
ip route default show ip route preferences
ip route distance show ip route summary
ip routing show ip traffic
show ip brief show ip vlan
2CSPC4.X8100-SWUM100.book Page 1070 Wednesday, August 29, 2012 6:23 PM