Command Line Interface Guide

IPv6 Routing Commands 1137
FF1E::1 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 2
FF1E::2 FE80::100:2.3 00:02:40 DELAY_MEMBER Include 1
FF1E::3 FE80::100:2.3 00:01:40 DELAY_MEMBER Exclude 0
FF1E::4 FE80::100:2.3 00:02:44 DELAY_MEMBER Include 4
show ipv6 mld-proxy groups detail
Use the show ipv6 mld-proxy groups detail command to display information
about multicast groups that MLD Proxy reported.
Syntax
show ipv6 mld-proxy groups detail
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC, Config mode and all Config sub-modes
User Guidelines
The following parameters are displayed by this command:
Field Description
Interface The interface number of the MLD-Proxy.
Group Address The IP address of the multicast group.
Last Reporter The IP address of the host that last sent a membership report for
the current group on the network attached to the MLD Proxy
interface (upstream interface).
Up Time (in
secs)
The time elapsed in seconds since last created.
2CSPC4.X8100-SWUM100.book Page 1137 Wednesday, August 29, 2012 6:23 PM