Command Line Interface Guide

1142 IPv6 Routing Commands
Syntax
show ipv6 neighbors
Syntax Description
This command has no arguments or keywords.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays information about the IPv6 neighbors.
console(config)#show ipv6 neighbors
Neighbor Last
IPv6 Address MAC
Address isRtr State Updated
Interface
-------------------- ----------------- ----- -------
---------
show ipv6 route
Use the show ipv6 route command in User EXEC or Privileged EXEC mode
to display the IPv6 routing table. The output of the command also displays
the IPv6 address of the default gateway and the default route associated with
the gateway.
2CSPC4.X8100-SWUM100.book Page 1142 Wednesday, August 29, 2012 6:23 PM