Command Line Interface Guide

IPv6 Routing Commands 1143
Syntax
show ipv6 route [ipv6-address | ipv6-prefix/prefix-length | protocol |
interface-type interface-number] [best]
Syntax Description
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the IPv6 address of the default gateway and
the default route associated with the gateway.
console(config)#show ipv6 route
IPv6 Routing Table - 0 entries
Parameter Description
ipv6-address Specifies an IPv6 address for which the best-matching route
would be displayed.
protocol Specifies the protocol that installed the routes. Is one of the
following keywords: connected, ospf, static.
ipv6-prefix/ prefix-
length
Specifies an IPv6 network for which the matching route would
be displayed.
interface-type
interface-number
Valid IPv6 interface. Specifies that the routes with next-hops on
the selected interface be displayed. Supported interface types
are VLAN, Tunnel, and Loopback.
best Specifies that only the best routes are displayed. If the
connected keyword is selected for protocol, the best option is
not available because there are no best or non-best connected
routes.
2CSPC4.X8100-SWUM100.book Page 1143 Wednesday, August 29, 2012 6:23 PM