Command Line Interface Guide

Command Groups 115
802.1x
vlan protocol group remove Removes the protocol-base VLAN group
identified by
groupid .
GC
a. For the meaning of each Mode abbreviation, see Mode Types on page 81.
Command Description Mode
a
dot1x dynamic-vlan enable Enables the capability of creating VLANs
dynamically when a RADIUS-assigned VLAN
does not exist in the switch.
GC
dot1x initialize Begins the initialization sequence on the
specified port.
PE
dot1x mac-auth-bypass Enables MAB on an interface. IC
dot1x max-req Sets the maximum number of times the switch
sends an EAP-request frame to the client before
restarting the authentication process.
IC
dot1x max-users Sets the maximum number of clients supported
on the port when MAC-based 802.1X
authentication is enabled on the port.
IC
dot1x port-control Enables manual control of the authorization
state of the port.
IC
dot1x re-authenticate Manually initiates a re-authentication of all
802.1x-enabled ports or a specified 802.1X
enabled port.
PE
dot1x reauthentication Enables periodic re-authentication of the client. IC
dot1x system-auth-control
monitor
Enables 802.1X globally. GC
dot1x timeout guest-vlan-
period
Sets the number of seconds that the switch
waits before authorizing the client if the client
is a dot1x unaware client.
IC
dot1x timeout quiet-period Sets the number of seconds the switch remains
in the quiet state following a failed
authentication attempt.
IC
Command Description Mode
a
2CSPC4.X8100-SWUM100.book Page 115 Wednesday, August 29, 2012 6:23 PM