Command Line Interface Guide

Multicast Commands 1177
--------------- --------------- --------------- -----
-----
1.1.1.1 255.255.255.0 2.2.2.2 23
show ip pim bsr-router
The show ip pim bsr-router command displays information about a bootstrap
router (BSR). This command deprecates the show ip pimsm componenttable
and show ip pimsm bsr commands.
Syntax
show ip pim bsr-router {candidate|elected}
• candidate – Shows the candidate routers capable of acting as the bootstrap
router.
• elected – Shows the router elected as the PIM bootstrap router.
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC, Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
The following information is displayed:
Field Description
BSR address IP address of the BSR.
BSR Priority The configured BSR priority.
BSR Hash Mask Length The configured hash mask length (32 bits maximum).
Next Bootstrap Message
in
Time remaining (in hours, minutes, and seconds) until a
BSR message is sent.
Next Candidate RP
Advertisement
Time remaining (in hours, minutes, and seconds) until the
next RP advertisement is sent.
2CSPC4.X8100-SWUM100.book Page 1177 Wednesday, August 29, 2012 6:23 PM