Command Line Interface Guide

IPv6 Multicast Commands 1199
Syntax
show ipv6 pim bsr-router
Default Configuration
There is no default configuration for this command.
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
There are no user guidelines for this command. Field descriptions are shown
in the following table.
Example
console#show ipv6 pim bsr-router
BSR Address...................... 2001:0db8:0:badc::1
BSR Priority.............................. 0
BSR Hash Mask Length...................... 32
C-BSR Advertisement Interval (secs)....... 60
Next Bootstrap message (hh:mm:ss)......... 00:00:02
If no configured/elected BSR’s exist on the router, the following message is
displayed:
Field Description
BSR Address Address of the BSR
BSR Priority Configured BSR priority
BSR Hash Mask
Length
Configured hash mask length
Next Bootstrap
Message
Remaining time until a BSR message is sent
Next Candidate RP
Advertisement
Time remaining until the next RP advertisement is sent.
2CSPC4.X8100-SWUM100.book Page 1199 Wednesday, August 29, 2012 6:23 PM