Command Line Interface Guide

1200 IPv6 Multicast Commands
No BSR’s exist/learned on this router.
show ipv6 pim interface
Use the show ipv6 pim interface command to display interface config
parameters. If no interface is specified, all interfaces are displayed.
Syntax
show ipv6 pim interface [ vlan vlan-id ]
• vlan-id—A valid VLAN ID value.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
There are no user guidelines for this command.
Example
console#show ipv6 pim interface vlan 6
Slot/Port...................................... vlan
6
IP Address.....................................
FE80::2FF:EDFF:FED0:2/128
Hello Interval (secs).......................... 30
Join Prune Interval (secs)..................... 60
Neighbor Count ................................ 0
Designated Router..............................
FE80::2FF:EDFF:FED0:2
2CSPC4.X8100-SWUM100.book Page 1200 Wednesday, August 29, 2012 6:23 PM