Command Line Interface Guide

1202 IPv6 Multicast Commands

show ipv6 pim rphash

Use the show ipv6 pim rphash command to display which rendezvous point

(RP) is being selected for a specified group.

Syntax

show ipv6 pim rphash

group-address

—Group IP address supported by RP.

Default Configuration

There is no default configuration for this command.

Command Mode

Privileged EXEC mode, Config mode and all Config sub-modes

User Guidelines

There are no user guidelines for this command.

Example

console#show ipv6 pim rphash ff1e::/64

RP Type

Address

------------------------ -----

3001::1 BSR

show ipv6 pim rp mapping

Use the show ipv6 pim rp mapping command to display all group-to-RP

mappings of which the router is aware (either configured or learned from the

bootstrap router (BSR). If no RP is specified, all active RPs are displayed

2CSPC4.X8100-SWUM100.book Page 1202 Wednesday, August 29, 2012 6:23 PM