Command Line Interface Guide

OSPF Commands 1215
• always — The router assumes the role of the translator when it becomes a
border router.
• candidate — The router to participate in the translator election process
when it attains border router status.
Default Configuration
The default role is candidate.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the translator role of the NSSA.
console(config-router)#area 20 nssa translator-role
always
area nssa translator-stab-intv
Use the area nssa translator-stab-intv command in Router OSPF
Configuration mode to configure the translator stability interval of the NSSA.
Syntax
area area-id nssa translator-stab-intv integer
no area area-id nssa translator-stab-intv
• area-id — Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
•
integer — The period of time that an elected translator continues to
perform its duties after it determines that its translator status has been
deposed by another router. (Range: 0–3600)
2CSPC4.X8100-SWUM100.book Page 1215 Wednesday, August 29, 2012 6:23 PM