Command Line Interface Guide

1216 OSPF Commands
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the translator stability interval of the area
20 NSSA.
console(config-router)#area 20 nssa translator-stab-
intv 2000
area range (Router OSPF)
Use the area range command in Router OSPF Configuration mode to
configure a summary prefix that an area border router advertises for a specific
area. There are two types of area ranges. An area range can be configured to
summarize intra-area routes. An ABR advertises the range rather than the
specific intra-area route as a type 3 summary LSA. Also, an area range can be
configured at the edge of an NSSA to summarize external routes reachable
within the NSSA. The range is advertised as a type 5 external LSA.
Use the no form of the command to delete an area range or revert an option
to its default.
Syntax
area area-id range prefix netmask {summarylink | nssaexternallink}
[advertise | not-advertise][cost
cost ]
no area
area-id range prefix netmask {summarylink | nssaexternallink}
2CSPC4.X8100-SWUM100.book Page 1216 Wednesday, August 29, 2012 6:23 PM