Command Line Interface Guide

1250 OSPF Commands
Default Configuration
Adjacency changes are not logged by default.
Command Mode
OSPFv2 Router Configuration mode
User Guidelines
State changes are logged with INFORMATIONAL severity.
max-metric router-lsa
Use the max-metric router-lsa command in router OSPF Global
Configuration mode to configure OSPF to enable stub router mode.
To disable stub router mode, use the no max-metric router-lsa command in
OSPFv2 Global Router Configuration mode.
Syntax
max-metric router-lsa [on-startup seconds ] [summary-lsa { metric }]
no max-metric router-lsa [on-startup] [summary-lsa]
Parameter Description
Default Configuration
By default, OSPF is not in stub router mode.
Parameter Description
on-startup (Optional) OSPF starts in stub router mode after a reboot.
seconds (Required if on-startup) The number of seconds that OSPF
remains in stub router mode after a reboot. The range is 5 to
86,400 seconds. There is no default value.
summary-lsa (Optional) Set the metric in type 3 and 4 summary LSAs to
LsInfinity (0xFFFFFF).
metric (Optional) Metric to send in summary LSAs when in stub
router mode. Range is 1 to 16,777,215. Default is 16,711,680
(0xFF0000).
2CSPC4.X8100-SWUM100.book Page 1250 Wednesday, August 29, 2012 6:23 PM