Command Line Interface Guide

1280 OSPF Commands
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example #1
The following example displays the information for the IFO object or virtual
interface tables associated with VLAN 3.
console#show ip ospf interface vlan 10
IP Address..................................... 1.1.1.1
Subnet Mask................................. 255.255.255.0
Secondary IP Address(es).......................
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
OSPF Network Type.............................. Broadcast
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 10 (computed)
Passive Status................................. Non-passive
interface
OSPF Mtu-ignore................................ Disable
State.......................................... designated-router
Designated Router.............................. 1.1.1.1
Backup Designated Router....................... 0.0.0.0
Number of Link Events.......................... 2
2CSPC4.X8100-SWUM100.book Page 1280 Wednesday, August 29, 2012 6:23 PM