Command Line Interface Guide

OSPF Commands 1281
Example #2
The following example shows the configuration of flood blocking.
console#show ip ospf interface gi2/0/11
IP Address........................... 172.20.11.2
Subnet Mask.......................... 255.255.255.0
Secondary IP Address(es).............
OSPF Admin Mode...................... Enable
OSPF Area ID......................... 0.0.0.0
OSPF Network Type.................... Point-to-Point
Router Priority...................... 1
Retransmit Interval.................. 5
Hello Interval....................... 3
Dead Interval........................ 12
LSA Ack Interval..................... 1
Transmit Delay....................... 1
Authentication Type.................. None
Metric Cost.......................... 100 (computed)
Passive Status....................... Non-passive interface
OSPF Mtu-ignore...................... Disable
Flood Blocking....................... Disable
State................................ point-to-point
Number of Link Events................ 1
Local Link LSAs...................... 0
Local Link LSA Checksum.............. 0
show ip ospf interface brief
Use the show ip ospf interface brief command in Privileged EXEC mode to
display brief information for the IFO object or virtual interface tables.
2CSPC4.X8100-SWUM100.book Page 1281 Wednesday, August 29, 2012 6:23 PM