Command Line Interface Guide

1292 OSPF Commands
------------- ------------- ---------- -------------
----
0.0.0.1 Normal 1 Enable
show ip ospf traffic
Use the show ip ospf traffic command in Privileged EXEC mode to display
OSPFv2 packet and LSA statistics and OSPFv2 message queue statistics.
Packet statistics count packets and LSAs since OSPFv2 counters were last
cleared (using the
clear ip ospf counters command.)
NOTE: Note that the clear ip ospf counters command does not clear the message
queue high water marks.
Syntax
show ip ospf traffic
Parameter Description
Parameter Description
OSPFv2 Packet
Statistics
The number of packets of each type sent and received since
OSPF counters were last cleared.
LSAs Retransmitted The number of LSAs retransmitted by this router since OSPF
counters were last cleared.
LS Update Max
Receive Rate
The maximum rate of LS Update packets received during any
5-second interval since OSPF counters were last cleared. The
rate is in packets per second.
LS Update Max
Send Rate
The maximum rate of LS Update packets transmitted during
any 5-second interval since OSPF counters were last cleared.
The rate is in packets per second.
Number of LSAs
Received
The number of LSAs of each type received since OSPF
counters were last cleared.
2CSPC4.X8100-SWUM100.book Page 1292 Wednesday, August 29, 2012 6:23 PM