Command Line Interface Guide

OSPF Commands 1295
• area-id — Identifies the OSPF area whose ranges are being displayed.
(Range: IP address or decimal from 0–4294967295)
•
neighbor-id — Identifies the neighbor’s router ID. (Range: Valid IP
address)
Default Configuration
Show information for all OSPF Virtual Interfaces.
Command Mode
User EXEC, Privileged EXEC modes, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 10 and its neighbor.
console#show ip ospf virtual-link 10 192.168.2.2
Area ID........................................ 10
Neighbor Router ID.............................
192.168.2.2
Hello Interval................................. 10
Dead Interval..................................
655555
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State.......................................... down
Metric......................................... 0
Neighbor State................................. down
Authentication Type............................ MD5
2CSPC4.X8100-SWUM100.book Page 1295 Wednesday, August 29, 2012 6:23 PM