Command Line Interface Guide

Command Groups 131
ip pim dr-priority Administratively configures the advertised
designated router (DR) priority value.
IC
ip pim hello-interval Administratively configures the PIM Hello
messages on the specified interface.
IC
ip pim join-prune-interval Administratively configures the frequency of
join/prune messages on the specified interface.
IC
ip pim register-rate-limit Sets a limit on the maximum number of PIM
register messages sent per second for each (S,G)
entry.
GC
ip pim rp-address Defines the address of a PIM RP for a specific
multicast group range.
GC
ip pim rp-candidate Configures the router to advertise itself to the
bootstrap router (BSR) as a PIM candidate
rendezvous point (RP) for a specific multicast
group range.
IC
ip pim sparse Administratively configures PIM sparse mode
for IP multicast routing.
GC
ip pim ssm Administratively configures PIM Source
Specific Multicast (SSM) range of addresses for
IP multicast routing.
GC
ip pim spt-threshold Sets the multicast traffic threshold rate for the
last-hop router to switch to the shortest path on
the router.
GC
show ip multicast Displays the system-wide multicast
information.
PE
show ip mcast boundary Displays the system-wide multicast
information.
PE
show ip multicast interface Displays the multicast information for the
specified interface.
PE
show ip mcast mroute Displays a summary or all the details of the
multicast table.
PE
show ip mcast mroute group Displays the multicast configuration settings of
entries in the multicast mroute table.
PE
Command Description Mode
a
2CSPC4.X8100-SWUM100.book Page 131 Wednesday, August 29, 2012 6:23 PM