Command Line Interface Guide

OSPFv3 Commands 1317
Default Configuration
1 is the default value for seconds .
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures a 20-second transmit delay for the OSPF
virtual interface on the virtual interface identified by area 1
and its neighbor.
console(config)#ipv6 router ospf
console(config-rtr)#area 1 virtual-link 2 transmit-
delay 20
default-information originate (Router OSPFv3
Configuration)
Use the default-information originate command in Router OSPFv3
Configuration mode to control the advertisement of default routes. Use the
no form of the command to return the default route advertisement settings
to the default value.
Syntax
default-information originate [always] [metric metric-value ] [metric-type
type-value]
no default-information originate [metric] [metric-type]
Syntax Description
Parameter Description
always Always advertise default routes.
2CSPC4.X8100-SWUM100.book Page 1317 Wednesday, August 29, 2012 6:23 PM