Command Line Interface Guide

1320 OSPFv3 Commands
Command Mode
Router OSPF Configuration mode.
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example sets a route preference value of 100 for intra OSPF in
the router.
console(config)#ipv6 router ospf
console(config-rtr)#distance ospf intra 100
enable
Use the enable command in Router OSPFv3 Configuration mode to enable
administrative mode of OSPF in the router (active).
Syntax
enable
no enable
Default Configuration
Enabled is the default state.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables administrative mode of OSPF in the router
(active).
2CSPC4.X8100-SWUM100.book Page 1320 Wednesday, August 29, 2012 6:23 PM