Command Line Interface Guide

OSPFv3 Commands 1321
console(config)#ipv6 router ospf
console(config-rtr)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPFv3 Configuration
mode to configure the exit overflow interval for OSPF. It describes the
number of seconds after entering Overflow state that a router will wait before
attempting to leave the Overflow State. This allows the router to originate
non-default AS-external-LSAs again. When set to 0, the router will not leave
Overflow State until restarted.
Syntax
exit-overflow-interval seconds
no exit-overflow-interval
• seconds — Exit overflow interval for OSPF (Range: 0-2147483647)
Default Configuration
0 is the default value for seconds .
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the exit overflow interval for OSPF at 100
seconds.
console(config)#ipv6 router ospf
console(config-rtr)#exit-overflow-interval 100
2CSPC4.X8100-SWUM100.book Page 1321 Wednesday, August 29, 2012 6:23 PM