Command Line Interface Guide

Command Groups 133
ipv6 pim dr-priority Sets the priority value for which a router is
elected as the designated router (DR).
IC
ipv6 pim hello-interval Administratively configures the PIM-SM Hello
Interval for the specified interface.
IC
ipv6 pim join-prune-interval Administratively configures the interface
join/prune interval for the PIM-SM router.
IC
ipv6 pim register-rate-limit Sets a limit on the maximum number of PIM
register messages sent per second for each (S,G)
entry
GC
ipv6 pim register-threshold Configures the Register Threshold rate for the
RP router to switch to the shortest path.
GC
ipv6 pim rp-address Statically configures the Rendezvous Point (RP)
address for one or more multicast groups.
GC
ipv6 pim rp-candidate Configures the router to advertise itself as a
PIM candidate rendezvous point (RP) to the
bootstrap router (BSR).
GC
ipv6 pim sparse (Global
config)
Administratively configures PIM sparse mode
for multicast routing.
GC
ipv6 pim spt-threshold Configures the Data Threshold rate for the last-
hop router to switch to the shortest path.
GC
ipv6 pim ssm Defines the Source Specific Multicast (SSM)
range of multicast addresses.
GC
show ipv6 pim Displays global status of IPv6 PIMSM and its
IPv6 routing interfaces.
PE or
GC
show ipv6 pim bsr Displays the bootstrap router (BSR)
information.
PE or
GC
show ipv6 pim bsr-router Display the bootstrap router (BSR)
information.
UE,
PE, or
GC
show ipv6 pim interface Displays interface config parameters. PE or
GC
Command Description Mode
a
2CSPC4.X8100-SWUM100.book Page 133 Wednesday, August 29, 2012 6:23 PM