Command Line Interface Guide

OSPFv3 Commands 1337
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-rtr)#passive-interface default
redistribute
Use the redistribute command in Router OSPFv3 Configuration mode to
configure the OSPFv3 protocol to allow redistribution of routes from the
specified source protocol/routers.
Syntax
redistribute {static | connected} [metric metric ] [metric-type {1 | 2}] [tag
tag ]
no redistribute {static | connected} [
metric ] [metric-type] [ tag ]
• metric — Metric value used for default routes. (Range: 0-16777214)
•
tag — Tag. (Range: 0-4294967295)
Default Configuration
2 is the default value for metric-type, 0 for tag .
Command Mode
Router OSPFv3 Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example configures the OSPFv3 protocol to allow
redistribution of routes from the specified source protocol/routers.
2CSPC4.X8100-SWUM100.book Page 1337 Wednesday, August 29, 2012 6:23 PM