Command Line Interface Guide

1342 OSPFv3 Commands
Example
The following example enables OSPF traps.
console#show ipv6 ospf
Router ID......................................
0.0.0.2
OSPF Admin Mode................................
Enable
ASBR Mode......................................
Disable
ABR Status.....................................
Disable
Exit Overflow Interval......................... 0
External LSA Count............................. 0
External LSA Checksum.......................... 0
New LSAs Originated............................ 0
LSAs Received.................................. 0
External LSDB Limit............................ No
Limit
Default Metric................................. Not
Configured
Maximum Paths.................................. 2
Default Route Advertise........................
Disabled
Always......................................... FALSE
Tag Shows the decimal value attached to each external route.
Subnets When this option is not configured, OSPF will only redistribute
classful prefixes.
Distribute-List Shows the access list used to filter redistributed routes.
2CSPC4.X8100-SWUM100.book Page 1342 Wednesday, August 29, 2012 6:23 PM