Command Line Interface Guide

1354 OSPFv3 Commands
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays brief ospf interface information.
console#show ipv6 ospf interface brief
Hello Dead Retrax LSA
Admin Router Int. Int. Int. Retrax Ack
Interface Mode Area ID Prior. Cost Val. Val. Val. Delay Intval
--------- -------- -------- ------ ----- ----- ----- ------ ------ -----
show ipv6 ospf interface stats
Use the show ipv6 ospf interface stats command in User EXEC mode to
display the statistics for a specific interface. The command only displays
information if OSPF is enabled.
Syntax
show ipv6 ospf interface stats vlan vlan-id
• vlan-id — Valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode, Config mode and all Config sub-modes
2CSPC4.X8100-SWUM100.book Page 1354 Wednesday, August 29, 2012 6:23 PM