Command Line Interface Guide

1358 OSPFv3 Commands
Syntax
show ipv6 ospf neighbor [interface-type interface-number] [neighbor-id]
Syntax Description
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Examples
The following examples display information about OSPF neighbors, in the
first case in a summary table, and in the second in a table specific to tunnel 1.
console#show ipv6 ospf neighbor
Router
ID Priority Intf Interface State Dead
ID Ti
me
--------- -------- ---- ----------- ------------- --
--
console#show ipv6 ospf neighbor interface tunnel 1
Parameter Description
interface-type Interface type, vlan or tunnel.
interface-number A valid interface number, a valid VLAN ID or tunnel identifier.
(Range is 0-7).
neighbor-id Valid IP address of the neighbor about which information is
displayed.
2CSPC4.X8100-SWUM100.book Page 1358 Wednesday, August 29, 2012 6:23 PM