Command Line Interface Guide

OSPFv3 Commands 1361
console#show ipv6 ospf stub table
AreaId TypeofService Metric Val Import
SummaryLSA
------------ ------------- ---------- -----------
------
0.0.0.10 Normal 1 Enable
show ipv6 ospf virtual-links
Use the show ipv6 ospf virtual-links command in Privileged EXEC mode to
display the OSPF Virtual Interface information for a specific area and
neighbor or for all areas in the system.
Syntax
show ipv6 ospf virtual-link [ area-id neighbor-id | brief]
• area-id — Identifies the OSPF area whose virtual interface information is
being displayed.
•
neighbor-id — Router ID of neighbor.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF Virtual Interface information for
area 1 and its neighbor.
console#show ipv6 ospf virtual-link 1 1.1.1.1
Area ID........................................ 1
2CSPC4.X8100-SWUM100.book Page 1361 Wednesday, August 29, 2012 6:23 PM