Command Line Interface Guide

1362 OSPFv3 Commands
Neighbor Router ID.............................
1.1.1.1
Hello Interval................................. 10
Dead Interval.................................. 40
Iftransit Delay Interval....................... 1
Retransmit Interval............................ 5
State..........................................
point-to-point
Metric......................................... 10
Neighbor State................................. Full
show ipv6 ospf virtual-link brief
Use the show ipv6 ospf virtual-link brief command in Privileged EXEC mode
to display the OSPFV3 Virtual Interface information for all areas in the
system.
Syntax
show ipv6 ospf virtual-link brief
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example
The following example displays the OSPF stub table.
console(config)#show ipv6 ospf virtual-link brief
2CSPC4.X8100-SWUM100.book Page 1362 Wednesday, August 29, 2012 6:23 PM