Command Line Interface Guide

140 Command Groups
ipv6 ospf Enables OSPF on a router interface or loopback
interface.
IC
ipv6 ospf area Sets the OSPF area to which the specified router
interface belongs.
IC
ipv6 ospf cost Configures the cost on an OSPF interface. IC
ipv6 ospf dead-interval Sets the OSPF dead interval for the specified
interface.
IC
ipv6 ospf hello-interval Sets the OSPF hello interval for the specified
interface.
IC
ipv6 ospf mtu-ignore Disables OSPF maximum transmission unit
(MTU) mismatch detection.
IC
ipv6 ospf network Changes the default OSPF network type for the
interface.
IC
ipv6 ospf priority Sets the OSPF priority for the specified router
interface.
IC
ipv6 ospf retransmit-
interval
Sets the OSPF retransmit interval for the
specified interface.
IC
ipv6 ospf transmit-delay Sets the OSPF Transmit Delay for the specified
interface.
IC
ipv6 router ospf Enters Router OSPFv3 Configuration mode. GC
maximum-paths Sets the number of paths that OSPF can report
for a given destination.
ROSV3
nsf Enables OSPF graceful restart. ROSV3
nsf helper Allows OSPF to act as a helpful neighbor for a
restarting router.
ROSV3
nsf helper strict-lsa-
checking
Requires that an OSPF helpful neighbor exit
helper mode whenever a topology change occurs.
ROSV3
nsf restart-interval Configures the length of the grace period on the
restarting router.
ROSV3
passive-interface Sets the interface or tunnel as passive. IC
passive-interface default Enables the global passive mode by default for all
interfaces.
ROSV3
Command Description Mode
a
2CSPC4.X8100-SWUM100.book Page 140 Wednesday, August 29, 2012 6:23 PM