Command Line Interface Guide

Captive Portal Commands 1461
• user-id —User ID (Range: 1–128).
•
timeout —Session timeout. 0 indicates use global configuration (Range:
0–86400 seconds).
Default Configuration
The global session timeout is used by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP)#user 1 session-timeout 86400
console(config-CP)#no user 1 session-timeout
Captive Portal Status Commands
show captive-portal configuration
Use the show captive-portal configuration command to display the
operational status of each captive portal configuration.
Syntax
show captive-portal configuration cp-id
cp-id
—Captive Portal ID.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
2CSPC4.X8100-SWUM100.book Page 1461 Wednesday, August 29, 2012 6:23 PM