Command Line Interface Guide

1462 Captive Portal Commands
User Guidelines
There are no user guidelines for this command.
Example
console#show captive-portal configuration 1
CP ID..................................... 1
CP Name................................... cp1
Operational Status........................ Disabled
Disable Reason............................
Administrator Disabled
Blocked Status............................ Not
Blocked
Configured Locales........................ 1
Authenticated Users....................... 0
show captive-portal configuration interface
Use the show captive-portal configuration interface command to display
information about all interfaces assigned to a captive portal configuration or
about a specific interface assigned to a captive portal configuration.
Syntax
show captive-portal configuration cp-id interface [{gigabitethernet
unit/slot/port| tengigabitethernet unit/slot/port | fortygigabitethernet
unit/slot/port}]
• cp-id —Captive Portal ID.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
2CSPC4.X8100-SWUM100.book Page 1462 Wednesday, August 29, 2012 6:23 PM