Command Line Interface Guide

1580 PHY Diagnostics Commands
Port Result Length [meters] Date
---- -------- --------------- ---------------
1/0/1 OK
1/0/2 Short 50 13:32:00 23 July
2004
1/0/3 Test has not been performed
1/0/4 Open 128 13:32:08 23 July
2004
1/0/5 Fiber - -
show fiber-ports optical-transceiver
Use the show fiber-ports optical-transceiver command in Privileged EXEC
mode to display the optical transceiver diagnostics.
Syntax
show fiber-ports optical-transceiver [ interface ]
• interface — A valid Ethernet port. The full syntax is unit / port.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
The show fiber ports command is only applicable to the SFP combo ports and
XFP ports (not the ports on the SFP+ plug-in module).
Examples
The following examples display the optical transceiver diagnostics.
console#show fiber-ports optical-transceiver
2CSPC4.X8100-SWUM100.book Page 1580 Wednesday, August 29, 2012 6:23 PM