Command Line Interface Guide

1634 Sflow Commands
• poll-interval — The sFlow instance polling interval. A poll interval of 0
disables counter sampling. A value of
n means once in n seconds a counter
sample is generated. (Range: 0–86400).
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#sflow 1 polling gigabitethernet
1/0/1-10 200
sflow polling (Interface Mode)
Use the sflow polling command in Interface Mode to enable a new sflow
poller instance for this data source if rcvr_idx is valid. Use the "no" form of
this command to reset poller parameters to the defaults.
Syntax
sflow rcvr-index polling poll-interval
no sflow rcvr-index polling
• rcvr-index — The sFlow Receiver associated with the poller (Range: 1 - 8).
•
poll-interval — The sFlow instance polling interval. A poll interval of 0
disables counter sampling. A value of n means once in n seconds a counter
sample is generated. (Range: 0 - 86400).
Default Configuration
There are no pollers configured by default.
2CSPC4.X8100-SWUM100.book Page 1634 Wednesday, August 29, 2012 6:23 PM