Command Line Interface Guide

Sflow Commands 1639
Example
console# show sflow 2 destination
Receiver Owner Time out Max Datagram Port IP Address
Index String Size
-------- -------- ---------- ------------ ----- --------------------------
2 0 1400 6343 0.0.0.0
show sflow polling
Use the show sflow polling command to display the sFlow polling instances
created on the switch.
Syntax
show sflow rcvr-index polling [{gigabitethernet | tengigabitethernet |
fortygigabitethernet}
interface-list ]
• rcvr-index — The sFlow Receiver associated with the poller (Range: 1–8).
•
interface-list — The list of interfaces to poll, in unit/slot/port format.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
The following fields are displayed:
Owner String The identity string for receiver, the entity making use of this
sFlowRcvrTable entry.
Time Out The time (in seconds) remaining before the receiver is released
and stops sending samples to sFlow receiver.
Max Datagram
Size
The maximum number of bytes that can be sent in a single sFlow
datagram.
Port The destination Layer4 UDP port for sFlow datagrams.
2CSPC4.X8100-SWUM100.book Page 1639 Wednesday, August 29, 2012 6:23 PM