Command Line Interface Guide

1652 SNMP Commands
show trapflags
Use the show trapflags command in Privileged EXEC mode to display the
trap settings.
Syntax
show trapflags [ospf|ospfv3|captive-portal]
Parameter Description
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
This command has no user guidelines.
Example #1
console#show trapflags
Authentication Flag......................... Disable
Auto-copy-sw Flag........................... Enable
Dot1q Flag.................................. Enable
Link Up/Down Flag........................... Enable
Maclock violation Flag...................... Enable
Multiple Users Flag......................... Enable
Parameter Description
ospf Display OSPFv2 specific trap settings.
ospfv3 Display OSPFv3 specific trap settings.
captive-portal Display captive-portal specific trap settings.
2CSPC4.X8100-SWUM100.book Page 1652 Wednesday, August 29, 2012 6:23 PM