Command Line Interface Guide

1694 Syslog Commands
Example
The following example places the designated server in logging configuration
mode.
console(config)#logging 192.168.15.1
logging audit
Use the logging audit command to enable switch auditing. Use the no form
of the command to disable switch auditing.
Syntax
logging audit
no logging audit
Default Configuration
The command default is enabled.
Command Mode
Global Configuration
Example
console(config)#logging audit
logging buffered
Use the logging buffered command in Global Configuration mode to limit
syslog messages displayed from an internal buffer based on severity. To cancel
the buffer use, use the no form of this command.
Sequence Number The message sequence number for this stack component.
Sequence numbers may be skipped because of filtering but are
always monotonically increasing on a per stack member basis.
Message An informative message regarding the event.
2CSPC4.X8100-SWUM100.book Page 1694 Wednesday, August 29, 2012 6:23 PM