Command Line Interface Guide

System Management Commands 1719
locate
Use the locate command to locate a switch by LED blinking.
Syntax
locate [switch unit ] [time time ]
Parameter Description
Default Configuration
Default value is 20 seconds.
Command Mode
Privileged EXEC
User Guidelines
The LED will blink green until it times out. The user may select a new time
value while the LED is blinking. The last value selected takes effect
immediately. The locate command does not persist across reboots.
Example
console# locate switch 1 time 555
login-banner
Use the login-banner command to enable login banner on the console, telnet
or SSH connection. To disable, use the no form of the command.
Parameter Description
switch unit If multiple devices are stacked, you can choose which
switch to identify.
time time LED blinking duration in seconds. Range 1-3600 seconds.
2CSPC4.X8100-SWUM100.book Page 1719 Wednesday, August 29, 2012 6:23 PM