Command Line Interface Guide

System Management Commands 1745
The following table explains the output parameters.
If you supply a value for
cardindex , the following additional information
appears as shown in the table below.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Config mode and all Config sub-modes
User Guidelines
The CID information is used when pre-configuring cards using the slot
command.
show supported switchtype
Use the show supported switchtype command in User EXEC mode to display
information about all supported switch types.
Parameter Description
Card Index (CID) The index into the database of the
supported card types. This index is used
when preconfiguring a slot.
Card Model Identifier The model identifier for the supported
card type.
Parameter Description
Card Type The 32-bit numeric card type for the
supported card.
Model Identifier The model identifier for the supported
card type.
Card Description The description for the supported card
type.
2CSPC4.X8100-SWUM100.book Page 1745 Wednesday, August 29, 2012 6:23 PM