Command Line Interface Guide

Using the CLI 175
Table 2-4. Interface Identifiers
When listed in command line output, gigabit Ethernet interfaces are
preceded by the characters
Gi , ten-gigabit Ethernet interfaces are preceded by
Te , and forty-gigabit Ethernet interfaces are preceded by Fo, as shown in the
examples below.
Port Channel Interfaces
Port-channel (or LAG) interfaces are represented in the CLI by the variable
port-channel-number ., which can assume values from 1-128 on most
PowerConnect switches.
When listed in command line output, port channel interfaces are preceded by
the characters
Po .
Loopback Interfaces
Loopback interfaces are represented in the CLI by the variable loopback-id ,
which can assume values from 0–7.
VLAN Interfaces
VLAN interfaces are represented in the CLI by the variable vlan-id , which can
can assume values from 1-4093.
Interface Type Long Form Short Form Identifier
Fast Ethernet fastethernet fa unit/slot/port
Gigabit Ethernet gigabitethernet gi unit/slot/port
10-Gigabit
Ethernet
tengigabitethernet te unit/slot/port
40-Gigabit
Ethernet
fortygigabitethernet fo unit/slot/port
Loopback loopback lo loopback-id (0-7)
Port Channel port-channel po port-channel-number
Tunnel tunnel tu tunnel-id (0-7)
Vlan vlan vl vlan-id (1-4093)
2CSPC4.X8100-SWUM100.book Page 175 Wednesday, August 29, 2012 6:23 PM