Command Line Interface Guide

1768 System Management Commands
console(config-stack)#
stack-port
Use the stack-port command in Stack Configuration mode to configure ports
as either Stacking ports or as Ethernet ports. This command is used to
configure Ethernet ports to operate as either stacking or Ethernet ports.
Syntax
stack-port {fortygigabitethernet|tengigabitethernet} unit/slot/port {ethernet
| stack}
Default Configuration
By default, Ethernet ports are configured to operate in Ethernet mode.
Command Mode
Stack Configuration mode
User Guidelines
The clear config command will not change the stacking port mode. Only the
stack-port command can change the operating mode of the stacking port and
it only takes effect after a reboot when changing between stacking and
Ethernet mode.
The stack-port configuration mode does not appear in the running config.
Use the show switch stack-port command to display configuration and status
of stacking ports. Ports that are configured to operate as stacking ports will
show as detached in the show interfaces status command output.
Use the show switch command to display information regarding the switches
in a stack. Fortygigabitethernet ports are only supported on the PC81xx
switches.
Example
console(config-stack)#stack-port tengigabitethernet
1/0/3 stack
2CSPC4.X8100-SWUM100.book Page 1768 Wednesday, August 29, 2012 6:23 PM