Command Line Interface Guide

System Management Commands 1773
Default Configuration
port — Telnet port (decimal 23) on the host.
Command Mode
User EXEC, Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
Following is an example of using the telnet command to connect to
176.213.10.50.
console#telnet 176.213.10.50
Esc U sends telnet EL
traceroute
Use the traceroute command in Privileged EXEC mode to discover the IP
routes that packets actually take when traveling to their destinations.
Syntax
traceroute [ ip | ipv6 ] ipaddress | hostname [ initTtl initTtl ] [ maxTtl
maxTtl ] [ maxFail maxFail ] [ interval interval ] [ count count ] [ port port ]
[ size
size ][source {<src-ip-address>|vlan <vlan-id>|loopback <loop-
id>}]
Parameter Description
Parameter Description
ipaddress Valid IP address of the destination host.
hostname Hostname of the destination host. (Range: 1–158 characters).
The command allows spaces in the host name when specified in
double quotes. For example,
console(config)#snmp-
server host "host name"
2CSPC4.X8100-SWUM100.book Page 1773 Wednesday, August 29, 2012 6:23 PM