Command Line Interface Guide

1774 System Management Commands
Default Configuration
The default count is 3 probes.
The default interval is 3 seconds.
The default size is 0 data bytes.
The default port is 33434.
The default initTtl is 1 hop.
The default maxTtl is 30 hops.
The default maxFail is 5 probes.
initTtl The initial time-to-live (TTL); the maximum number of router
hops between the local and remote system (Range: 0–255).
maxTtl The largest TTL value that can be used (Range:1–255).
maxFail Terminate the traceroute after failing to receive a response for
this number of consecutive probes (Range: 0–255).
interval The timeout period. If a response is not received within this
period of time, then traceroute considers that probe a failure
(printing *) and sends the next probe. If traceroute does receive
a response to a probe, then it sends the next probe immediately.
(Range: 1–60 seconds).
count The number of probes to be sent at each TTL level
(Range:1–10).
port The destination UDP port of the probe. This should be an
unused port on the remote destination system (Range:
1–65535).
size The size, in bytes, of the payload of the Echo Requests sent
(Range: 0–65507 bytes).
src-ip-address The IPv4 source address to use in the ICMP echo request
packets.
vlan A valid VLAN interface.
loop-id A configured loopback ID
Parameter Description
2CSPC4.X8100-SWUM100.book Page 1774 Wednesday, August 29, 2012 6:23 PM