Command Line Interface Guide

AAA Commands 253
• password — Password for this level (Range: 8- 64 characters).
•
encrypted — Encrypted password entered, copied from another switch
configuration.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
The 4.x firmware emulates industry standard behavior for enable mode
authentication over SSH and telnet. In 4.x, the default enable authentication
method for telnet and SSH uses the enableNetList method, which requires an
enable password. If users are unable to enter privileged mode when accessing
the switch via telnet or SSH, the administrator will need to either change the
enable authentication method, e.g. to enableList, or set an enable password.
If the encrypted parameter is specified, the password parameter is stored as
entered in the running-config. No attempt is made to decode the encrypted
password.
Example
The following example defines password "xxxyyyzzz" to control access to user
and privilege levels.
console(config)# enable password xxxyyyzzz
ip http authentication
Use the ip http authentication command in Global Configuration mode to
specify authentication methods for http server users. To return to the default,
use the no form of this command.
Syntax
ip http authentication method1 [ method2 ...]
no ip http authentication
2CSPC4.X8100-SWUM100.book Page 253 Wednesday, August 29, 2012 6:23 PM