Command Line Interface Guide

258 AAA Commands
console(Config-IAS-User)#password 1f3ccb1157
console(Config-IAS-User)#exit
console(config)#
password (Line Configuration)
Use the password command in Line Configuration mode to specify a
password on a line. To remove the password, use the no form of this
command.
NOTE: For commands that configure password properties, see Password
Management Commands on page 1559.
Syntax
password password [encrypted]
no password
• password — Password for this level. (Range: 8- 64 characters)
•
encrypted — Encrypted password to be entered, copied from another
switch configuration.
Default Configuration
No password is specified.
Command Mode
Line Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example specifies a password "mcmxxyyy" on a line.
console(config-line)# password mcmxxyyy
2CSPC4.X8100-SWUM100.book Page 258 Wednesday, August 29, 2012 6:23 PM