Command Line Interface Guide

306 Address Table Commands
mac address-table multicast static
Use the mac address-table multicast static command in Global
Configuration mode to register MAC layer Multicast addresses to the bridge
table and to add ports to the group statically. To deregister the MAC address,
use the no form of the mac address-table multicast static command.
Syntax
mac address-table multicast static vlan vlan-id { mac-multicast-address | ip-
multicast-address
} [add | remove] [interface {gigabitethernet | port-
channel | tengigabitethernet | fortygigabitethernet}
interface-list ]
no mac address-table multicast static vlan
Parameter Description
Default Configuration
No Multicast addresses are defined.
Command Mode
Global Configuration mode
Parameter Description
add Adds ports to the group. If no option is specified, this is the
default option.
remove Removes ports from the group.
vlan vlan-id Valid vlan ID (1-4093).
mac-multicast-
address
MAC multicast address in the format xxxx.xxxx.xxxx.
ip-multicast-address IP multicast address.
interface
interface-
list
Specify a comma separated list of interfaces, a range of
interfaces, or a combination of both. Interfaces can be port-
channel numbers or physical ports in unit/slot/port format.
2CSPC4.X8100-SWUM100.book Page 306 Wednesday, August 29, 2012 6:23 PM