Command Line Interface Guide

Address Table Commands 321
1/0/1 Locked Discard 3 Enable 100
1/0/2 Unlocked - 28 - -
1/0/3 Locked Discard, Shutdown 8 Disable -
The following table describes the fields in this example.
show ports security addresses
Use the show ports security addresses command in Privileged EXEC mode to
display current dynamic addresses in locked ports.
Syntax
show ports security addresses {gigabitethernet unit/slot/port | port-channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet
unit/slot/port }
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
Field Description
Port The port number.
Status The status can be one of the following: Locked
or Unlocked.
Actions Action on violations.
Maximum The maximum addresses that can be associated
on this port in Static Learning mode or in
Dynamic Learning mode.
Trap Indicates if traps would be sent in case of
violation.
Frequency The minimum time between consecutive traps.
2CSPC4.X8100-SWUM100.book Page 321 Wednesday, August 29, 2012 6:23 PM