Command Line Interface Guide

DHCP Layer 2 Relay Commands 353
Parameter Description
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Config mode and all Config sub-modes
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay circuit-id vlan 300
DHCP L2 Relay is Enabled.
DHCP Circuit-Id option is enabled on the following
VLANs:
300
show dhcp l2relay remote-id vlan
Use the show dhcp l2relay remote-id vlan command in Privileged EXEC
mode to display whether DHCP L2 Relay is globally enabled and shows the
remote ID configured on the specified VLAN or VLAN range.
Syntax
show dhcp l2relay remote-id vlan vlan-range
Parameter Description
vlan-range Show information for the specified VLAN range. A range may
be a single VLAN ID or two VLAN IDs separated by a single
dash with no embedded spaces.
2CSPC4.X8100-SWUM100.book Page 353 Wednesday, August 29, 2012 6:23 PM